STM SatLink 2000 - Page 155

SatLink VSAT User Guide
Publication no. 101557
Copyright © 2009 – STM Group, Inc.
Page 154 (160)
Event Severity User action required Comment
DNS WARNING Normal Check configuration
of the DNS primary
and secondary IP
address.
No connectivity with DNS server
Ip Address for Major None The STM SatLink VSAT IP address of the
LAN or DVB interface is changed. New
IP address is visible in the log.
Ip NetMask for Major None The STM SatLink VSAT network mask of
the LAN or DVB interface is changed.
New network mask is visible in the log
Created virtual Inf Major None A virtual interface is created
Deleted virtual Inf Major None A virtual interface is deleted
Route added Major None A new IP route is configured in the STM
SatLink VSAT.
Save Config Executed Major None The STM SatLink VSAT configuration is
saved.
No Global NAT Addr
defined
Major Add global NAT
address to the
VSAT
configuration
The STM SatLink VSAT NAT
functionality is enabled but no global
NAT address is defined.
VSAT IP cannot be
used as Global NAT
Addr
Major Check NAT
configuration of the
VSAT.
The STM SatLink VSAT does not allow
to use the DVB address as global NAT
address.
BIP List Minor None The STM SatLink VSAT has added web
site in the HTTPA bypass list.
Events for Mesh capable only SatLink VSAT
DLCP logon
successful
Normal None The STM SatLink VSAT has successfully
logged to the Mesh Controller.
DLCP logon Failure:
Unauthorised Logon
Minor If the problem
persists, contact
your hub operator.
The STM SatLink VSAT was refused to
logon to the Mesh Network. Contact your
Hub operator. The VSAT DVB and LAN
IP address and subnet must fall into the
mesh network address space to get
authorised to logon.
DLCP link
establishment success
Normal None The STM SatLink VSAT has established a
new dynamic connection
DLCP link service
failed
Minor If the problem
persists, contact
your hub operator.
The mesh controller
might be out of
service.
The STM SatLink VSAT was not able to
establish a new dynamic connection.
DLCP link service tear
down timeout
Normal None A dynamic connection is closed due to
timeout. Timeout occurs when no packet
are received in any direction for a certain
amount of time configured by the Hub
operator.
DLCP link service tear
down last link service
Normal None The STM SatLink VSAT is closing the
last dynamic connection.
DLCP link service tear
down
Normal None A dynamic connection is closed either
from the STM SatLink VSAT or the Mesh
Controller.