AN4989 Rev 3 109/118
AN4989 Managing various targets on the same PC
117
Appendix C Managing various targets on the same PC
This appendix provides hints to identify and control the connection to a specific target
among several ones using ST-LINK probe.
Each ST-LINK connection is identified by a serial number.
In order to correlate a serial number with a board, it is advised to use
STM32CubeProgrammer.
At the top of the screen, the serial number pick list contains all connected ST-LINK probes.
By selecting one, access to the target is generated, making blinking of the related ST-LINK
LED switch from red to green.
Figure 84. STM32CubeProgrammer target selection pick list
Once the target is identified, it is possible to copy the S/N from the console in the clip-board
as shown in
Figure 85.
To Next Page
Loading...
