Name: STMicroelectronics STM32
Brand: STMicroelectronics
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Printf debugging AN4989

84/118 AN4989 Rev 3

Debug configuration

In Run -> Debug configuration -> Debugger tab, change the debugger probe to ST-LINK

(Open OCD).

In Generator options, choose “Software system reset“as reset Mode.

Figure 63. Semihosting in STM32CubeIDE – Debug configuration

In the Startup tab enter the command: monitor arm semihosting enable.

Questions and Answers:

Need help?

Do you have a question about the STMicroelectronics STM32 and is the answer not in the manual?

STMicroelectronics STM32 Specifications

General