STMicroelectronics STM32 - Iar Ewarm; Figure 27. Reset Mode in IAR8.10: Screenshot

AN4989 Rev 3 43/118
AN4989 Connecting to the board
117
4.2.2 IAR™ EWARM
Reset and Connection mode are seen as a single reset mode option as shown in Figure 27.
Figure 27. Reset Mode in IAR8.10: screenshot
• System (default): Normal Connection. Software System Reset prior to jump at main.
• Core: Normal Connection. Software Core Reset prior to jump at main.
• Software: Normal Connection. No Reset prior to jump and stop at main.
• Hardware: Normal Connection. Assert NRST MCU pin prior to jump to main.
• Connect during reset: Connection while asserted Hardware NRST.
Hotplug connection is accessible with “Attach to running Target” function in project menu.