STMicroelectronics STM32 - Figure 90. Error Message for Multiple ST-LINK Detected in Stm32 Cubeide

AN4989 Rev 3 113/118
AN4989 Managing various targets on the same PC
117
Figure 90. Error message for multiple ST-LINK detected in STM32CubeIDE
• Setting up with OpenOCD
rIt is possible to force the connection to a specific target using the ST-LINK S/N.
In Run -> Debug Configurations -> Debugger Pane, add the following OpenOCD option:
-c hla_serial [ST-LINK S/N]
Figure below illustrates the setting of an OpenOCD option for forcing a connection.