Creating a VLAN
VLAN attached to a single interface (VLAN endpoint)
Address range
IPv4 address When this option is selected, the VLAN will have an IPv4 address. If this address is
static, this has to be indicated in the field below the checkbox along with its network
mask. By default, a dynamic address will be assigned to it via DHCP.
IPv6 address When this option is selected, the VLAN will have a static IPv6 address. Enter this
address and its associated network mask in CIDR notation (example:
2001:db8::70/32), in the field below the checkbox.
VLAN attached to 2 interfaces (crossing VLAN)
VLAN address range
Use an existing bridge When this option is selected, you will need to select from the drop-down list the bridge
to which the VLAN will be attached.
Create a new bridge When this option is selected, a wizard will allow you to create a new bridge containing
both of the interfaces to which the VLAN is attached.
IPv4 address When this option is selected, the VLAN will have an IPv4 address. If this address is
static, this has to be indicated in the field below the checkbox along with its network
mask. By default, a dynamic address will be assigned to it via DHCP. This option is only
available if you have chosen to create a new bridge.
IPv6 address When this option is selected, the VLAN will have a static IPv6 address. Enter this
address and its associated network mask in CIDR notation (example:
2001:db8::70/32), in the field below the checkbox. This option is only available if you
have chosen to create a new bridge.
Modifying a VLAN
“Configuration of the interface” tab
Address range
Hybrid resolution When this option is selected, the interface must have at least an IPv4 address
(dynamic or static) and an IPv6 address (static). In this case, you will need to indicate
these IP addresses and their associated network mask in the tables “IPv4 address
range” and “IPv6 address range”.
“Router Advertisement (RA)” tab
For options regarding Router advertisements, please refer to the paragraph “Router advertisement
(RA)” tab in the menu Modifying a Bridge.
“Advanced properties” tab
For advanced VLAN configuration options please refer to the paragraph “Advanced configuration”
tab in the menu Modifying an Ethernet interface (in bridge mode).
Page 378/448 sns-en-user_configuration_manual-v3 - Copyright © Stormshield 2016
SNS - USER CONFIGURATION MANUAL V.3
IPV6 SUPPORT
To Next Page
Loading...
