Stormshield SN series - Cli Console; List of Commands; Data Entry Zone

CLI CONSOLE
Thismodule will allow you to view executable commands on your appliance’s CLI (Command Line
Interface) console.
You can access it from the menu System > CLI.
This module consists of two sections:
l the list of commands in the upper part of the window, which is a text zone
l a data entry zone at the bottom of the window
To obtain the full executable commands, refer to the guide CLI Serverd Commands reference
Guide available in your secure area, under the section Documentation.
List of commands
The window displays by default the 16 main executable commands that are part of the “HELP”
category.
NOTE
By entering the “HELP” command in the data entry zone that we will see later, the list that
summarizes the main commands will appear again.
The following are the visible commands:
AUTH Used with the aim of avoiding spoofing, this command allows the user or the
administrator to authenticate in total security.
CHPWD Allows redefining the password if necessary.
CONFIG Allows accessing the firewall’s configuration features, which group 38 implicit
commands (ACTIVATE CONFIG, ANTISPAM CONFIG etc., cf “Data entry zone”).
GLOBALADMIN Allows obtaining information about the system and consists of two implicit commands:
GETINFOS and GETSTATUS.
HA: Allows accessing high availability features, grouping 8 commands.
HELP This command, as indicated earlier, allows displaying the list of main executable
commands.
LIST Displays the list of connected users, by showing user privileges (by level) and
privileges for the session in progress (SessionLevel).
LOG Allows viewing the Stormshield Network multifunction firewall’s activity logs, groups 6
commands.
MODIFY This command is a specific privilege that allows the user to modify the configuration of
a module, in addition to reading privileges.
MONITOR Allows accessing features relating to MONITOR, contains 20 commands.
NOP Does not perform any action and while preventing the server from logging off.
PKI Allows displaying or downloading the PKI, groups 7 commands.
QUIT Allows logging off.
SYSTEM Groups 20 commands relating to the system.
USER Groups 12 commands relating to the user.
VERSION Allows displaying the version of the server.
Data entry zone
When you go to the CLI module, the focus is on the command entry field.
Page 75/448 sns-en-user_configuration_manual-v3 - Copyright © Stormshield 2016
SNS - USER CONFIGURATION MANUAL V.3
CLI CONSOLE