CONFIGURATION OF MONITORING
Monitoring curves and data are compiled based on logs saved on the firewall. Such logs will then
be analyzed.
This screen is divided into 2 sections:
l Top: settings of the various refreshment times
l Bottom: a table listing throughout two tabs the network interfaces and QoS queues to be
monitored.
Interval between refreshments
Maximum period
displayed (in minutes)
This setting makes it possible to define the data period to be displayed for a curve.
This period is expressed in minutes and may take on one of the following values: 15,
30, 45 or 60.
Curve refreshment
time (in seconds)
This parameter allows defining the refreshment time of monitoring curves. This period
is expressed in seconds and may take on one of the following values:5, 10, 15 or 20.
Table refreshment
time (in seconds)
This parameter allows defining the refreshment time of monitoring data set out on the
tables. This period is expressed in minutes and may take on one of the following
values: 1, 3, 5, 7 and 10.
Configuration of interfaces and QoS queues to be monitored
"Interface configuration" tab
It is possible to Add or Delete interfaces to be monitored by clicking on the corresponding
buttons.
The table contains the following columns:
Name Select the interface that needs to be monitored. The suggested interfaces are the Ethernet
interfaces and modem interfaces (dialup).
"QoS configuration" tab
It is possible to Add or Delete QoS queues to be monitored by clicking on the corresponding
buttons. These queues must be defined beforehand in the Security policy > Quality of service
module.
The table contains the following columns:
Name Select from the drop-down list the QoS queue that needs to be monitored.
Page 84/448 sns-en-user_configuration_manual-v3 - Copyright © Stormshield 2016
SNS - USER CONFIGURATION MANUAL V.3
CONFIGURATION OF MONITORING
To Next Page
Loading...
