Stratasys Objet500 - Page 196

Objet500 User Guide 6 Operating and Maintaining the Objet500 3DPrinter
DOC-07027 Rev.E 6-65
Figure6-94Sensorpreparation
3. ConfirmtheitemslistedinthewizardscreenandclickNext.
Continuewith"UV Measurement " on the next page
ExternalUVMeter
Thefollowingstepsapplywhenusingastand-aloneUVmeter.Theydonot
applywhenusingtheStratasysUVsensorboxconnectedtotheprinter.
1. Whenthefollowingscreenappears,opentheprinterandplacetheUV
sensorboxattherearedgeofthetray,inthecenter.
Figure6-95Sensorplacementscreen