8
PART 1 • English
Group Rename
In this menu you can change the name of favourite groups. Use the pq buttons to select Group
Rename and press OK to enter.
1. Select a group with pq and press OK.
2. Use the pqtu buttons to navigate the on screen keyboard. Highlighted characters
can be inserted by pressing OK. After entering the desired group name, highlight OK
at the keyboard to confirm.
3. Press EXIT to cancel the group rename.
5.2 Installation
5.2.1 Auto Scan
1. Use the pq buttons to select Installation and press OK to enter menu.
2. Use pq to select Auto Scan and press OK to enter the menu.
3. Change the Scan Mode with tu select Free for searching Free To Air channels only or
All for all channel search.
4. Use pq to highlight Action and select Reinstall to create a new channel list or Update
to update the current channel list with newly found channels.
5. Use pq to highlight Search and press OK to start auto scan.
5.2.2 Channel Scan
1. Use the pq buttons to select Installation and press OK to enter the menu.
2. Select Channel Scan with pq and press OK to enter.
3. Use the tu buttons to select the desired Scan Modes – By Channel or By Frequency.
4. When By Channel is selected use the cursor buttons to select Scan Band and Channel
No.. When By Frequency is selected use the cursor buttons to select Frequency and
Bandwidth. Set Network Search to ON or OFF, highlight Search and press OK to
start scanning. Found channels will be stored and the receiver will switch to the first
channel in the list.
5.2.3 Antenna Setting
1. Press MENU to enter main menu.
2. Use the pq buttons to select Installation and press OK to enter the menu.
3. Select Antenna setting with pq and press OK to enter.
4. Use the tu buttons to change the setting. If On is selected, the receiver will provide
5V antenna power (for active antennas).
5. Press EXIT button to exit.
5.2.4 LCN Mode
If LCN (Logical Channel Numbering) is activated and LCN signal is provided by the operator,
channels will be stored in operator defined order. You can activate/deactivate the LCN function by
setting the LCN Mode to ON or OFF.
To Next Page
Loading...
