14
PART 1 • English
From EPG
Press the EPG button to enter the programme guide. Select an event and channel with the buttons
described on screen. Once the desired event is highlighted, press 4 / 4 to plan a timer on this event.
The event time will be copied into a free Program Timer. It is possible to adjust the start and duration
time for this timed event.
Manual scheduling
You can set a record manually via the Timer menu. For details refer to chapter 5.3.4 Timer Setting.
NOTE: In case there is not enough space on the connected USB device, the
recording operation will stop automatically. The maximum allowed Time
shift setting is 1h. Available record types: TS: Transport stream including
Teletext, subtitles etc. PS: Program stream for video and audio only. With SRT
5303 you can watch one programme while recording another one within the
same frequency.
WARNING: Please consider that Time shift needs min. 0,58 GB free space on the USB
device and an accurate Time shift function is depending on the speed of the
used USB device.
6.0 OPERATION
6.1 Changing Channels
There are 4 ways of channel selection: stepping through the channel list, selection by number, from
the on-screen channel list, and using the electronic programme guide (EPG).
1. Stepping through the channel list
To move through the channel list, use the pq buttons on the remote control.
2. Selection by direct channel number input
Enter the channel number directly by using numeric buttons, and press the OK button
to select the channel.
3. Selection by on-screen channels list
You can also select the required channel directly from on-screen channel list. To
call up the channel list, OK in viewing mode. Alternatively, the list can be displayed
using the receiver’s main menu. See chapter 5.1.1 TV Channel list in this manual for
operation details.
4. Selection via EPG
You can also select the required channel directly from electronic programme guide
(EPG).
To display the EPG, press EPG on remote control. See chapter 6.2 below for details.
6.2 Accessing the Electronic Program Guide (EPG)
1. Press EPG to enter EPG menu.
2. Use the numeric button 2 to switch the highlight between channel list, events
schedule of the selected channel and now/next events.
To Next Page
Loading...
