16
PART 1 • English
Problem Possible cause What to do
After moving the receiver
to another room / area you
are no longer able to receive
digital reception
Antenna signals are too weak/
coming from different antenna
Antenna feed may come
through a distribution
system which may reduce the
digital signal
Press the INFO button on
remote 3x to call up signal
bars and adjust antenna for
(maximum) reception or
rescan channels
Try a direct feed from
the antenna
or try to use an active
room antenna
The receiver switches
off automatically.
Auto Standby function enabled. Disable auto standby. See
section 5.3.8 for details.
The USB storage device is not
correctly working
Wrong format or other reasons See chapter 1.5 Usage of
external USB devices
8.0 SPECIFICATIONS
Demodulator:
Demodulator: COFDM; 16 QAM/64 QAM
Transmission mode: 2 K - 8 K
Video Decoder:
Profile level: MPEG2 MP@ML
Video resolution: 720 x 576 pixels (PAL), 720 x 480 (NTSC)
Decoding & Video Out: PAL & NTSC
Aspect ratio: 4:3, 16:9
Audio Decoder:
MPEG MusiCam Layer 2
Sampling rate: 32, 44.1, 48 KHz
Audio mode: Stereo, Joint Stereo, Dual Mono, Mono
Tuner:
Front End: DVB-T, UHF & VHF Tuner
Input frequency range: 174 – 230 MHz (VHF) and 470 - 862 MHz (UHF)
Loop through frequency range: 47 - 862 MHz
Input signal level: -82 ~-20 dBm
Multimedia:
Video playback – MPEG1 and MPEG2 encoded (mpg)
Audio playback – MP3 and WMA formats
Picture view – JPEG format
To Next Page
Loading...
