STRONG HD STB User’s Manual
11
Dolby Digital Audio
If you have a Dolby Digital Decoder Amplifier, you can connect to the amplifier by S/PDIF
i.e either by Connector 6: Coaxial Cable or Connector 12: Optical Cable. (Both leads
need to be purchased separately). This connection will provide for Dolby Digital Output
when broadcast to your decoder amplifier
To ‘Enable’ Dolby Digital to be heard when transmitted within the broadcast stream, you
will need to select Dolby Digital In the TV Set Up Menu or by the SAP button on the
remote control
Dolby Digital by Menu System
Press the Menu button (Page 7 No.26) on the remote control and a Main Menu Banner will
be viewed listing 7 topics.
Using Remote Control Up/Down Scoll Buttons, Scroll to Set Up
Push Remote Control OK Button (main centre button of Remote Control: Button 24)
Set Up banner will be viewed listing 9 topics
Scroll to Digital Audio and push OK button on the remote control
Digital Audio banner will be viewed with right hand banner listing Digital Audio and PCM
Scroll to Digital Audio and setting will be confirmed by a RED dot.
Push OK to confirm the setting
Push EXIT to return to normal TV broadcasts
Dolby Digital by SAP button of the Remote Control
Press the SAP button on the remote Control
Digital Audio banner will be viewed with right hand banner listing Digital Audio and PCM
Scroll to Digital Audio and setting will be confirmed by a RED dot.
Push OK to confirm the setting
Push EXIT to return to normal TV broadcasts
Connector 6 S/PDIF Coaxial Connect to the Coaxial input of your Amplifier
Connector 12 S/DIF Optical Connect to the Optical input of your Amplifier
To Next Page
Loading...
