ELECTRICAL HAZARD
Disconnecting the unit from the electrical power supply must only be done by a
qualified technician.
3. Clean and dry the unit.
Requirements
• Make sure that the floor of the working area and the transportation corridor are designed to carry
the following weight:
Weight
Machine 960 kg (2116 lbs)
• Make sure that the following facilities are available:
– Power supply
– Water supply
– Compressed air supply
– Water drain
Moving the machine
To move the machine, use a fork-lift truck and a crossbar.
Note
The machine must be installed by Struers technicians or by an authorized service
technician trained by Struers for this specific task.
Procedure
1. Open the recirculation module doors .
2. Make sure that the transportation crossbar and wheels supplied with the machine are secured
in position before you start lifting.
3. Loosen the brackets on the transportation crossbar to allow movement.
4. Adjust the brackets.
5. On the front of the machine, press and hold the crossbar against the bottom of the wheels.
6. Slide the brackets of the transport crossbar over the edges of the wheels and tighten the bolts.
7. Position the forklift as close to the center line of gravity as possible. See also: Lift the machine
►23
46 Xmatic
5 Transport and storage
To Next Page