5 Transport and storage
If, at any time after the installation, you have to move the unit or place it in storage, there is a
number of guidelines we recommend that you follow.
• Package the unit securely before transportation. Insufficient packaging could cause damage
to the unit and will void the warranty. Contact Struers Service.
• We recommend that you use the original packaging and fittings.
5.1 Storage
• Disconnect the unit from the electrical power supply.
• Disconnect the unit from the water supply.
• Disconnect the unit from the compressed air supply.
• Disconnect the unit from the drain.
• Remove any accessories.
• Clean and dry the unit before storage.
• Place the machine and accessories in their original packaging.
5.2 Transport
To transport the machine safely, follow these instructions.
1. Make sure that the following items are available:
– Transport brackets (x 2)
– Transport crossbar (x 1)
– Bar with wheels (x 2)
– The original pallet
Note
We recommend that you keep all original packaging and fittings for future
use.
2. If needed, disconnect the following:
– Power supply
– Compressed air supply
– Water supply
– Recirculation unit. See the manual supplied with the specific equipment.
– Disconnect the monitor. This must be done by StruersService.
– Accessories
5 Transport and storage
Xmatic 45
To Next Page