Stryker X7000 - Factory Service Instructions; Required Equipment for Repair; Required Skills for Technicians; Required Replacement Components

2
1.7 FACTORY SERVICE INSTRUCTIONS
If service is needed either during or after the warranty
period:
Contact Stryker Endoscopy at 1-800-624-4422 or contact
your local Stryker Endoscopy sales representative. If
needed, a loaner unit may be requested during the time of
your unit repair.
Package the X-7000 carefully in the original shipping con-
tainer, if possible.
Ship the Stryker Endoscopy X-7000 Light Source, prepaid
and insured, to:
Stryker Endoscopy Customer Service
Attention: Repair Department
5900 Optical Court
San Jose, CA 95138
1.8 REQUIRED EQUIPMENT
Most of the procedures described in this manual require
the following basic tool kit:
• Small flat blade screwdriver
• Medium Philips screwdriver
• 8” adjustable wrench
• Needlenose pliers
• Small wire cutting pliers
• Wire stripper
• Soldering iron and solder
•Multimeter
• Stryker medical video camera
•Stryker Scope
•Fiber optic cable
• Glass fuse puller
•Shorting clip
• Bio Tek Model 170 Analyzer or equivalent current
leakage tester
• Nut drivers 11/32” and 5/16”
• Open end wrenches 7/16” and 1/2”
• Set of standard allen wrenches / hex keys
•Hi-Pot Tester
1.9 REQUIRED SKILLS
Each diagnostic and repair procedure described in this
manual requires a technician qualified by training or expe-
rience in the following areas:
•Basic electronics techniques
•Multimeter operation
1.10 REQUIRED REPLACEMENT COMPONENTS
If a repair procedure necessitates replacements parts,
please refer to the Appendix (page 22).