EasyManuals Logo

Subaru Outback 2012 User Manual

Subaru Outback 2012
474 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #205 background imageLoading...
Page #205 background image
Black plate (208,1)
Model "A2480BE-A" EDITED: 2011/ 7/ 26
5-22 Audio
! Category selection (type C audio)
Change the cate-
gory up by one step
Change the cate-
gory down by one
step
To activate the category search mode,
press the
or button. When in the
category search mode, press the
or
button to change the category up or
down.
When a category is selected, turning the
TUNE dial selects channels only within
the selected category.
The control function returns to the normal
mode after approximately 6 seconds.
! Channel scan (type C audio)
SCAN/A.S button
Press the SCAN/A.S button to change
the radio to the SCAN mode. In this mode,
under the selected category, the radio
scans through the channel until a station
is found. The radio will stop at the station
for 5 seconds while displaying the channel
number, after which scanning will continue
until the entire channel has been scanned.
Press the SCAN/A.S button again to
cancel the SCAN mode and to stop on any
displayed channel.
& Channel preset
! How to preset channels
1. Press the SAT button to select SAT1,
SAT2 and SAT3 reception.
2. Select the desired channel.
3. Press and hold one of the preset
buttons (from
to ) to store the
channel. If the button is pressed briefly,
the preceding selection will remain in the
memory.
NOTE
. Up to six SAT1, SAT2 and SAT3
channels each may be preset.
. If the connection between the radio
and battery is broken for any reason
such as vehicle maintenance or radio
removal, all channe ls stored in the
preset buttons are cleared. If this
occurs, it is necessary to reset the
preset channels.
! Selecting preset channels
1. Press the SAT button to select SAT1,
SAT2 or SAT3 reception.
2. Press the preferred preset button
(from
to ) briefly.
& When the following mes-
sages are displayed (type C
audio)
If one of the following messages is
displayed when receiving XM signals,
determine the cause based on the follow-
ing information. If you cannot clear these
messages, contact your SUBARU dealer.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Subaru Outback 2012 and is the answer not in the manual?

Subaru Outback 2012 Specifications

General IconGeneral
BrandSubaru
ModelOutback 2012
CategoryAutomobile
LanguageEnglish

Related product manuals