Black plate (221,1)
北米Model "A2480BE-A" EDITED: 2011/ 7/ 26
operation, disconnect the connection
cable from the iPod
®
and reset it. For
the resetting procedure, see the User’s
Guide of the iPod
®
.
. If an iPod
®
and the connection cable
are connected improperly, the iPod
®
cannot be powered on or will not be
recognized by in-vehicle equipment. In
this case, disconnect the connection
cable from the iPod
®
, and then connect
it again.
The USB connector is located in the
center console. Use the connector to
connect a USB storage device/iPod
®
.
& How to play back
NOTE
. Depending on the number of files
stored on the iPod
®
and the firmware
version, the iPod
®
may not activate
smoothly after operation or not work
properly.
. Do not disco nnect the connector
from the iPod
®
during iPod
®
operation.
! Type B audio
1. Connect a USB storage device/iPod
®
.
2. Press the
button. Each time you
briefly press the button, the mode
changes as follows.
When the USB/iPod
®
mode is selected,
the player will start playback of the USB
storage device/iPod
®
.
! Type C audio
! When a USB storage device/iPod
®
is
not connected
Connect a US B storage device/iPod
®
.
Then the player will start playback of the
USB storage device/iPod
®
.
! When a USB storage device/iPod
®
is
already connected
Press the button. Each time you
briefly press the button, the mode
changes as follows.
When the USB/iPod
®
mode is selected,
the player will start playback of the USB
storage device/iPod
®
.
& To select a track from the
beginning
Select a track in the same way as for a
CD. For details, refer to “To select a track
from the beginning” F5-24.
& To select a chapter from the
beginning when connecting
iPod
®
When playing podcasts or audiobooks,
select a chapter in the same way as for a
CD. For details, refer to “To select a track
from the beginning” F5-24.
& Fast-forwarding and rewind-
ing
Fast-forwarding and rewinding are oper-
ated in the same way as for a CD. For
Audio 5-35
– CONTINUED –
5
To Next Page
Loading...
