Black plate (231,1)
北米Model "A2480BE-A" EDITED: 2011/ 7/ 26
entered.
2. Input the new passkey (a 4 - 8 digit
number) by operating the “TUNE” dial.
3. Select the “CONFIRM” menu.
– The new passkey is displayed, the
passkey is changed and the mode
changes to the Bluetooth
®
audio
setting mode.
! Deleting device
1. Select the “DELETE AUDIO” menu.
– If no devices are registered,
“EMPTY” is displayed and the mode
changes to the Bluetooth
®
audio
setting mode.
2. Select the “CONFIRM” menu.
–“DELETED” is displayed and the
mode changes to the Bluetooth
®
audio setting mode.
& Setting Bluetooth
®
audio
(type C audio)
1. Press the button to select the
“BT Audio” mode.
Talk switch
2. Press the talk switch .
NOTE
If a device and a cell phone are already
registered, “BT” menu will be dis-
played. Then perform the following
procedure.
(1) Press the talk switch
and
say “Setup”.
(2) Press the talk switch
again
and say “Bluetooth audio setup”.
The “BT Audio Setup” will then be
displayed.
3. After the “BT Audio Setup” menu is
displayed, select the following menus by
using the voice command system or by
operating the “TUNE” dial.
NOTE
. You cannot set Bluetooth
®
audio
while driving.
. After the ignition switch is turned to
the “LOCK” position, the registered
device/cell phone may be automatically
connected to the system if the ignition
switch is turned to the “Acc” or “ON”
position.
. When a cell phone is already con-
nected, the system will disconnect the
phone to setup a new device. You may
need to reconnect the phone after
setup is complete.
. Up to 2 devices (excluding cell
phones for Hands-free system) can be
registered.
. Up to 6 devices (including cell
phones for Hands-free system) can be
registered.
! By using voice command system
NOTE
If no devices are registered, you can
only select from the following menu.
. “Pair audio player” (refer to “Regis-
tering (paring) device” F5-46)
. “Set passkey” (refer to “Selecting
device” F5-46)
Audio 5-45
– CONTINUED –
5
To Next Page
Loading...
Need help?
General
