Black plate (58,1)
北米Model "A2480BE-A" EDITED: 2011/ 7/ 26
1-34 Seat, seatbelt and SRS airbags
! Outback
Three tether anchorages, i.e., ones for the
right, center and left positions, are already
installed on the rear edge of the roof.
Open the cover flap to use each ancho-
rage.
! To hook the top tether
CAUTION
Always remove the head restraint
when mounting a chi ld re straint
system with a top tether. Failure to
do so may prevent the top tether
from being fastened tightly.
! Legacy
1. Fold down the rear seatback for the
window side seating position. Refer to
“Folding down the rear seatback” F1-9.
2. Remove the head restraint at the
seating position where the child restraint
system has been installed with the seat-
belt or lower anchorages; lift up the head
restraint while pressing the release button.
Store the head restraint in the trunk. Avoid
placing the head restraint in the passen-
ger compartment to prevent it from being
thrown around in the passenger compart-
ment in a sudden stop or a sharp turn.
3. Open the cover flap s to use the
anchorages.
To Next Page
Loading...
