Black plate (126,1)
一般Model "A2510GE-B" EDITED: 2015/ 6/ 25
2-18
Keys and doors/PIN Code Access (models with “keyless access with push–button start system”)
8. Within 5 seconds after step 7 is
performed, close the door. A chirp sound
will be heard, and the functions are
disabled.
NOTE
In steps 4 and 6, press the power door
locking switch firmly. If the switch is
not pressed firmly, the functions may
not be disabled.
! Enabling functions
When the procedure to disable the func-
tions is performed again, a chirp sound will
be heard, and the functions are enabled.
& When access key does not
operate properly
Refer to “Access key – if access key does
not operate properly” F9-29.
& Replacing battery of access
key
Refer to “Replacing battery of access key”
F11-61.
& Technical information for
Europe models
. This device complies with the essential
requirements of the Radio and Telecom-
munications Terminal Equipment Directive
1999/5/EC. A copy of the original Declara-
tion of Conformity and the CE marking are
found in chapter 13.
. Hereby, DENSO CORPORATION de-
clares that this 14AHB is in compliance
with the essential requirements and other
relevant provisions of Directive 1999/5/
EC.
PIN Code Access (models
with “keyless access with
push-button start system”)
1) Trunk opener button (Sedan)
To Next Page
Loading...
