EasyManua.ls Logo

Subaru Outback 2015 - Rear Seatbelt Indicator Light (if Equipped)

Subaru Outback 2015
610 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Black plate (164,1)
Model "A2510GE-B" EDITED: 2015/ 6/ 25
3-14
Instruments and controls/Warning and indicator lights
! Seatbelt warning for front passen-
gers seat (if equipped)
Your vehicle is equipped with a seatbelt
warning device for the front passengers
seat.
Front passengers warning light
With the ignition switch turned to the ON
position, this device reminds the front
passenger to fasten his/her seatbelt by
illuminating a warning light as shown in
the illustration.
If the vehicle is driven at a speed no
higher than approximately 20 km/h (12.5
mph) with the front passengers seatbelt
not fastened, the warning light(s) corre-
sponding to the unfastened seatbelt(s) will
illuminate continuously.
If the vehicle su bsequently reaches a
speed of approximately 20 km/h (12.5
mph) with the front passengers seatbelt
not fastened, the warning light(s) will start
a repeated cycle consisting of 5 seconds
of flashing followed by 1 second of steady
illumination.
At the same time, a buzzer will start a
repeated cycle consisting of sounding for
5 seconds followed by a 1-second pause.
If either the drivers or front passengers
unfastened seatbelts is fastened at this
time, the warning light corresponding to
that seatbelt will immediately turn off but
the buzzer will continue operating unless
the remaining seatbelt is fastened.
NOTE
. If the drivers and front passengers
seatbelts are not fastened simulta-
neously (if one seatbelt is fastened
significantly earlier or later than the
other), the buzzer may sound longer
(10 seconds maximum).
. The occupant detection system of
the front passengers seat detects if the
seat is occupied by a passenger. How-
ever, if there is an object on the seat,
the seatbelt warning system may be
activated even the seat is not occupied.
. If you use a cushion on the front
passengers seat, there is the possibi-
lity that the occupant detection system
cannot detect the passenger.
If the drivers seatbelt and/or the front
passengers seatbelt is still not fastened
when the 108-second period has elapsed,
the warning light(s) will stop flashing and
the buzzer will stop sounding. The warn-
ing light(s), however, will remain illumi-
nated continuously unless the corre-
sponding seatbelt(s) is fastened.
& Rear seatbelt indicator light
(if equipped)
1) Rear seat (left position)
2) Rear seat (center position)
3) Rear seat (right position)
This indicator light illuminates to show
only the seating positions in which seat-
belts have not been fastened.

Table of Contents

Related product manuals