Black plate (548,1)
一般Model "A2510GE-B" EDITED: 2015/ 6/ 25
11-56
Maintenance and service/Replacing bulbs
& Back-up light (Outback)
1. Apply a flat-head screwdriver to the
light cover as shown in the illustration, and
pry the light cover off from the rear gate
trim.
2. Turn the bulb socket counterclockwise
and remove it.
3. Pull the bulb out of the bulb socket and
replace it with a new one.
4. Install the bulb socket by turning it
clockwise.
5. Install the light cover on the rear gate.
& Rear fog light (Outback)
NOTE
It may be difficult to replace the bulb.
We recommend that you have the bulb
replaced by your SUBARU dealer if
necessary.
1. Remove the bulb cover inside the rear
bumper by removing the screw.
2. Turn the bulb socket counterclockwise
and remove it.
To Next Page
Loading...
