Black plate (186,1)
一般Model "A2510GE-B" EDITED: 2015/ 6/ 25
3-36
Instruments and controls/Information display
The clock shows the time while the
ignition switch is in the “ACC” or “ON”
position.
To adjust the time shown by the clock,
press the “+” button or the “−” button. If
you press the “+” button, the indicated
time will change in one-minute incre-
ments. If you press the “−” button, the
indicated time will change in one-minute
decrements. If you keep the bu tton
pressed, the rate at which the indicated
time changes will speed up.
& Climate control mode indica-
tors
1) Set temperature indicator (left-hand side)
2) Set temperature indicator (right-hand
side)
3) Maximum air conditioner ON indicator
4) Air conditioner ON indicator
5) FULL AUTO indicator
6) AUTO indicator
7) Airflow mode indicator
8) Fan speed indicator
& Outside temperature indica-
tor
The outside temperature indicator shows
the outside temperature in a range from
−30 to 508C(−22 to 1228F).
The indicator can give a false reading
under any of the following conditions:
. When there is too much sun.
. During idli ng; while ru nning at low
speeds in a traffic jam; when the engine
is restarted immediately following a shut-
down.
. When the actual outside temperature
falls outside the specified indicator range.
To Next Page
Loading...
