Black plate (554,1)
一般Model "A2510GE-B" EDITED: 2015/ 6/ 25
11-62
Maintenance and service/Replacing battery
4. Insert a new battery with its positive (+)
side facing upward as shown in the figure.
5. Attach the cover to the access key by
fitting the projections and recesses to-
gether.
& Replacing battery of trans-
mitter
! Models without TPMS
1. Open the key head using a flat-head
screwdriver.
2. Remove the three screws and then
remove the cover.
3. Create a gap between the battery and
the case by pushing the battery gently
with your finger as shown in the illustra-
tion. Then, insert a flat-head screwdriver
that has been wrapped in insulating tape
into the gap.
To Next Page
Loading...
