Black plate (555,1)
一般Model "A2510GE-B" EDITED: 2015/ 6/ 25
4. Move the flat-head screwdriver in the
order shown in 1. and 2., and remove the
battery, taking care not to damage the
base panel or terminal.
5. Remove the old battery.
6. Fit a new battery (type CR-1620 or
equivalent) in the case with its positive (+)
side facing upward.
7. Put the case together by fitting the
mating part of the button side into the hook
on the key side.
After the battery is replaced, the trans-
mitter must be synchronized with the
remote keyless entry system’s control
unit. Press either the “
” or “ ” button
several times to synchronize the unit.
! Models with TPMS
1. Open the key head using a flat-head
screwdriver.
Maintenance and service/Replacing battery
11-63
– CONTINUED –
11
To Next Page
Loading...
