Black plate (163,1)
一般Model "A2510GE-B" EDITED: 2015/ 6/ 25
: Oil pressure warning light
: Engine low oil level warning indicator
: AT OIL TEMP warning light
(CVT models)
: ABS warning light
: Brake system warning light (red)
: Electronic parking brake warning light
(yellow)
: Hill Holder indicator light
: Low fuel warning light
: Low tire pressure warning light
(if equipped)
: Vehicle Dynamics Control warning
light/Vehicle Dynamics Control opera-
tion indicator light
: Vehicle Dynamics Control OFF indica-
tor light
: Preheating indicator light
(diesel engine models)
: Hill descent control indicator (if
equipped)
If any lights fail to illuminate, it indicates a
burned-out bulb or a malfunction of the
corresponding system.
We recommend that you consult your
authorized SUBARU dealer for repair.
& Seatbelt warning light
and chime
NOTE
If your seatbelt warning device does
not operate as described below, it may
be out of order. We recommend that
you have the device inspected and, if
necessary, repa ired by the nearest
SUBARU dealer.
! Seatbelt warning for driver’s seat
Your vehicle is equipped with a seatbelt
warning device for the driver’s seat.
Driver’s warning light
This device causes the seatbelt warning
light on the combination meter to illumi-
nate when the ignition switch is turned to
“ON” to remind the driver to wear the
seatbelt.
If the vehicle is driven at a speed no
higher than approximately 20 km/h (12.5
mph) with the driver’s seatbelt not fas-
tened, the warning light will illum inate
continuously.
If the vehicle subsequently reaches a
speed of approximately 20 km/h (12.5
mph) with the driver’s seatbelt not fas-
tened, the warning light will start a
repeated cycle consisting of 5 seconds
of flashing followed by 1 second of steady
illumination. At the same time, a buzzer
will start a repeated cycle consisting of
sounding for 5 seconds followed by a 1-
second pause. If the seatbelt is fastened
at this time, the warning light will turn off
and the buzzer will stop sounding imme-
diately.
This condition will continue for approxi-
mately 108 seconds. If the driver’s seat-
belt is still not fastened when the 108-
second period has elapsed, the warning
light will stop flashing and the buzzer will
stop sounding. The warning light, how-
ever, will remain illuminated continuously
unless the seatbelt is fastened.
Instruments and controls/Warning and indicator lights
3-13
– CONTINUED –
3
To Next Page
Loading...
