Black plate (196,1)
一般Model "A2510GE-B" EDITED: 2015/ 6/ 25
3-46
Instruments and controls/Multi information display
. Detection is not possible
Select “On” to activate the buzzer. Select
“Off” to deactivate the buzzer.
! Lead Vehicle Moving Monitor
Function
When adaptive cruise control is used, the
buzzer that sounds if a vehicle in front has
started can be activated or deactivated.
Select “On” to activate the buzzer. Select
“Off” to deactivate the buzzer.
! Vehicle Icon
The vehicle icon indication can be acti-
vated or deactivated. Select “On” to
activate. Select “Off” to deactivate.
! Vehicle Setting
After entering the “Vehicle Setting” menu,
select one of the following menus.
! Keyless Entry System
You can change some of the settings of
the remote ke yless en try sy stem (al l
models) and keyless access with push-
button start system (if equipped).
After entering the “Keyless Entry System”
menu, select one of the following menus.
. Audible Signal:
The audible signal can be activated or
deactivated. Select “On” to activate. Se-
lect “Off” to deactivate.
. Hazard Warning Flasher:
The hazard warning flasher operation can
be activated or deactivated. Select “On” to
activate. Select “Off” to deactivate.
. Security Relocking:
The automatic locking operation period
can be set or customized. Sele ct the
preferred seconds to customize the op-
eration period. Select “Off” to deactivate
the operation.
. Driver Door Unlock:
The door unlock selection function for the
driver’s door can be activated or deacti-
vated. Select “On” to activate. Select “Off”
to deactivate.
. Rear Gate/Trunk Unlock:
The door unlock selection function for the
rear gate/trunk can be activated or deac-
tivated. Select “On” to activate. Select
“Off” to deactivate.
! Defogger
The defogger and deicer system can be
set for the continuous operation mode or
automatic shut-off mode. Select “Contin-
uous” to select the continuous operation
mode. Select “15 minutes” to select the
automatic shut-off mode.
! Interior Light
The setting for the period of time in which
the interior lights remain on (OFF delay
timer) after closing the doors and/or the
rear gate can be set or customized. Select
the preferred seconds to customize the
operation period. Select “Off” to deactivate
the OFF delay timer.
! Auto Light Sensor
The operational sensitivity of the auto on/
off headlights can be set. You can select
“Max”, “Mid”, “Low” or “Min”.
! Default Settings
Select “Yes” to use the menu screen to
restore customized settings to the factory
default settings. Select “No” to return to
the previous screen without restoring to
the factory default settings.
To Next Page
Loading...
