2-8
2.Basic splicing operation｜Optical fiber splicing
2. Basic splicing operation
●
Turning on/off the splicer
1: Ensure that the electrodes are fully
inserted in the splicer.
2: Insert the output cord of the AC
adapter into the DC input terminal.
3: Adjust the monitor angle to your own
preference.
4: Press the Power key ( ) for more
than 1 second to turn on the power.
Each motor of the splicer is initialized
after turning on the power, and then
Home screen is displayed after a few
seconds.
Output cord of
the AC adapter
■Turnin
on the splicer
Power key
■Turnin
of
the splicer
Press the Power key ( ) for more than 1 second to turn off the power.
If you press the Power key right after
connecting the power cord to the power
supply module, it may take a few seconds
until the splicer is powered on.
Settings panel screen
▸P.1-11 Screens and icons
After splicer is turned on,
Home screen is displayed
To display the Settings panel,
tap the Settings panel icon
( ）on the Home screen.
Home screen
❚
Optical fiber splicing
To Next Page
Loading...
