5-5
5. Heater program｜Showing/hiding heater programs (in Administrator mode)
5. Heater program
3: After is selected, the
selected heater program will
be hidden in the Operator
mode.
▸P.4-5 Showing/Hiding splice program
An administrator can show or hide heater programs in the Operator mode.
First, log in to Administrator mode to do this action.
(▸P.8-1 Logging in to and logging out of Administrator mode）
2: Tap to switch
between ON⇔OFF.
1: Referring to the procedures in
Page 5-4, go to “Heater
Program edit screen”. Tap the
Pencil icon ( ) at the right
upper corner of the screen.
The heater program which is currently selected for use cannot be hidden. To hide
the program, first select other program to deselect the program, and then do the
above procedures.
Once heater program is displayed in the Operator mode, it is still saved after the
power is switched off.
❚
Showing/Hiding heater program (in Administrator mode)
To Next Page
Loading...
