2-27
2. Basic splicing operation｜Drop cable splicing
2. Basic splicing operation
1: Open the hood.
Take great care not to touch the fiber
end face against any surfaces.
4: Close the hood.
5: Start the splicing process.
3: Make sure that the fiber sits in the
V-groove correctly.
▸Perform an arc test prior
to splicing.
2: Place the fiber holder onto the fiber
holder stage, fitting the pin of the
stage into the hole of the fiber holder.
For details on arc test and
splicing procedures, please
refer to the page below.
▸P.2-15 Arc test
▸P.2-17 Starting the automatic
splice
●
Inserting the fiber into the splicer
To Next Page
Loading...
