2-13
2.Basic splicing operation｜Optical fiber splicing
2. Basic splicing operation
5: Open the top clamp lever.
Then open the lid of the single
fiber adapter and lift the newly
cleaved fiber. Lift the off-cut
and dispose it properly.
1: Do not re-clean the fiber after cleaving.
2: To avoid damaging or contaminating a delicate fiber end, insert
the fiber in the splicer immediately after preparation.
3: Glass-fiber fragments are extremely sharp. Handle with care.
Bare fiber
Cleave
length
Fiber coating
・By using fiber cleaver (FC-6S-5C), a cleave length of 5-20mm is available (φ0.25mm &
φ0.9mm). Please confirm the manual of fiber cleaver (FC-6S-5C) about detailed
procedure.
To Next Page
Loading...
