5-2
5. Heater program｜Heater program list
5. Heater program
The applicable fiber protection sleeves vary depending on the cleave length. Below
are examples of protection sleeves.
■ Protection sleeves
❚
Heater program list
The heating programs are optimized for Sumitomo protection sleeves. Select an
appropriate heater program for the protection sleeve you are using.
Category Heater program Details
Drop
60mmDrop
Can be used for heat shrinking 60mm protection sleeves for drop
cable splice, for example, Sumitomo FPS-D60.
40mmDrop
Can be used for heat shrinking 40mm protection sleeves for drop
cable splice.
Splice-On
Connector
LYNX
Can be used for heat shrinking protection sleeves for 10mm cleaved
Sumitomo’s splice-on-connector “Lynx-CustomFit™”.
LYNX MINI
Can be used for heat shrinking protection sleeves for 5mm cleaved
Sumitomo’s splice-on-connector “Lynx-CustomFit™”.
E-SC Fusion
Can be used for heat shrinking dedicated protection sleeves for
Sumitomo “E-SC Fusion Connector”.
SPS
45mm Thin
Can be used for heat shrinking 45mm semi-shrunk protection
sleeves for single fiber, for example, SPS-45.
25mm 0.4
Can be used for heat shrinking 25mm protection sleeves of Nano
Sleeves N4 series, for example, Sumitomo FPS-N4-25.
25mm 0.9
Can be used for heat shrinking 25mm protection sleeves of Nano
Sleeves N9 series, for example, Sumitomo FPS-N9-25.
20mm 0.4
Can be used for heat shrinking 20mm protection sleeves of Nano
Sleeves N4 series, for example, Sumitomo FPS-N4-20.
20mm 0.9
Can be used for heat shrinking 20mm protection sleeves of Nano
Sleeves N9 series, for example, Sumitomo FPS-N9-20.
Protection
Sleeve
Sleeve Length
[mm]
Diameter After
shrink [mm]
Coating Diameter
[mm]
Recommended
Cleave length
[mm]
FPS-1 60.5 Approx.3.2 0.25 to 0.9 16
FPS-40 40.5 Approx.3.2 0.25 to 0.9 10
FPS-61-2.6 61.5 Approx.2.6 0.25 to 0.9 16
FPS-D60 60.5 Approx.4.5×4.7
Drop/Indoor cable
2.0×3.1(o
2.6)
1.6×2.0
10
To Next Page
Loading...
