Seite 3 BB_ENG_991305_04_16
BUDDYBOX Operating Manual
1. General information
Please observe the following warnings!
Electrical hazard
Misapplication of the machine may be dangerous, risk of severe or fatal injury.
Imminent danger
Misapplication of the machine may be dangerous and lead to severe injures.
Dangerous situation
Risk of physical injury.
Damaging situation
Risk of machine damage.
Helpful information
Disposal
Please observe legal /environmental regulations.
2. Safety advice
Do not attempt to install or operate the CYCLO DRIVE until all of these instructions on assem-
bly, operation, maintenance and inspection and hazards are read and thoroughly understood.
Please keep these instructions next to the unit in operation to check at any time when neces-
sary.
Transportation, assembly, lubrication, operation, maintenance and inspection should only be
done by qualied personnel, so as to avoid personal injury or damage to property.
Do not touch moving mechanical components and make sure these parts are clear of
obstructions. Failure to follow these instructions may result in personal injury, unit failure or
damage to property.
Only operate the unit in the application it was intended. Misapplication may result in physical
injury or damage to machinery.
3. Transportation recommendations
The units must be checked for any transportation damage immediately upon receipt. Any
damages should be reported to the carrier without delay. If there is any evidence of damage
which may put at risk the function of the CYCLO DRIVE, do not install the unit.
Lifting harnesses of suitable and adequate size are to be used; these are to be hooked into
the eye bolts or laid round the ange connections. Eye bolts on the gearbox are dimensioned
for the weight of the unit, no additional loads are allowed.
Caution: do not use the central bores in the shaft ends for lifting the drive with hooked bolts,
etc. This could result in damage to the bearings.
To Next Page
Loading...
Need help?
General
