2-1
CHAPTER
2
Removing and Replacing
Components
This chapter tells you how to remove and replace the components that are located
behind the server’s front bezel. The procedures documented in this chapter do not
require the attention of qualified service personnel.
Caution – Read the section, Section 2.2, “Avoiding Electrostatic Discharge” on
page 2-2, and wear a properly grounded antistatic strap, before you carry out any of
the procedures in this section.
The chapter contains the following sections:
■ Section 2.1, “Replaceable Components” on page 2-2
■ Section 2.2, “Avoiding Electrostatic Discharge” on page 2-2
■ Section 2.4, “Swapping a System Configuration Card Between Servers” on
page 2-6
■ Section 2.5, “Removing and Replacing Hard Drives” on page 2-7
■ Section 2.6, “Removing and Replacing the DVD Drive” on page 2-12
To Next Page
Loading...
Need help?
General
