6-14 Sun Fire V210 and V240 Servers Administration Guide • December 2005
6.6.2 probe-ide Command
The probe-ide command communicates with all Integrated Drive Electronics (IDE)
devices connected to the IDE bus. This is the internal system bus for media devices
such as the DVD drive.
Caution – If you used the halt command or the Stop-A key sequence to reach the
ok prompt, then issuing the probe-ide command can hang the system.
The following is sample output from the probe-ide command.
CODE EXAMPLE 6-3 sample probe-ide Command Output
6.6.3 show-devs Command
The show-devs command lists the hardware device paths for each device in the
firmware device tree. The following code example shows sample output from the
show-devs command.
{1} ok probe-ide
Device 0 ( Primary Master )
Removable ATAPI Model: DV-28E-B
Device 1 ( Primary Slave )
Not Present
Device 2 ( Secondary Master )
Not Present
Device 3 ( Secondary Slave )
Not Present
CODE EXAMPLE 6-4 show-devs Command Output
ok show devs
/pci@1d, 700000
/pci@1c,600000
/pci@1e,600000
/pci@1f,700000
/memory-controller@1,0
/SUNW,UltraSPARC-IIIi@1,0
/memory-controller@0,0
To Next Page
Loading...
Need help?
General
