Chapter 3 Sun Advanced Lights Out Manager 3-7
3.4.3 To Set the Serial Port Speed Back to the Default
● Type the following:
3.4.4 scadm resetrsc Command
If two users are running ALOM at the same time and one user issues the scadm
resetrsc command for Solaris OS while the other user is updating ALOM
firmware using either the scadm download command or the ALOM shell
command flashupdate, the firmware could become corrupted and cause ALOM to
be unusable.
■ Do not issue the scadm resetrsc command until after the firmware update is
complete.
■ Do not issue the scadm resetrsc command within 60 seconds after the
firmware update has been completed.
3.4.5 TTYB Console Output
If you have your console set to TTYB (10101) rather than to TTYA (the ALOM serial
port, labeled SERIAL MGT), you may not see all the output from the console. This is
because both OpenBoot PROM and Power-On Self-Test (POST) send diagnostic
output to TTYA by default.
sc> bootmode reset-nvram
sc> reset
To Next Page
Loading...
Need help?
General
