xii Sun Blade 150 Getting Started Guide • June 2002
Chapter 3 describes how to start the workstation’s preinstalled software
applications.
Chapter 4 describes how to install optional workstation hardware such as DIMMs,
PCI cards, graphics accelerators, CD-ROM or DVD-ROM drives, and hard drives.
Chapter 5 describes workstation troubleshooting.
Safety and Compliance Information
For your protection, observe the following safety precautions when installing,
setting up, and troubleshooting your Sun Blade 150 workstation.
Caution – Sun products are designed to work with single phase power systems
having a grounded neutral conductor. To reduce the risk of electric shock, do not
plug Sun products into any other type of power system. Contact your facilities
manager or a qualified electrician if you are not sure of the type of power supplied
to your building.
Caution – Hazardous voltages are present. To reduce the risk of electric shock and
danger to personal health, follow the instructions.
Caution – Do not operate Sun products without the top cover in place. Failure to
follow this precaution may result in personal injury or equipment damage.
Caution – There is a risk of personal injury and equipment damage. Follow the
instructions.
The Sun Blade 150 Safety and Compliance Information document (816-4778-10) contains
a listing of safety precautions for the Sun Blade 150 workstation. The safety and
compliance document is located in the packing carton for the Sun Blade 150
workstation.
To Next Page
Loading...
Need help?
General
