Preparing your Sunbeam
Caffe Bellissimo
Fitting the tray for tall glasses
The tray enables the use of taller glasses.
To fit:
Push the drip tray with the cup grate into
the coffee machine until it snaps into
place.
Lift the front of the coffee machine
slightly, centre and push the tray from the
front under the coffee machine. Lower the
coffe machine and allow the tray to snap
in. Refer to Figure 1.
Fitting the coffee bean container
It is possible to increase the capacity of the
coffee bean container to 450g.
To increase the coffee bean container size:
Remove the lid (a) of the coffee bean
container by opening it to an upright
position and pulling it out of its holder.
Remove the lid (b) of the pre-ground coffee
shaft by opening it to an upright position
and turning to the right or left to pull it out
of its holder. Refer to Figure 2.
a
Figure 2
Place the larger coffee bean container on
top of the smaller bean container.
See Figure 3.
Figure 3
Note: Make sure that the grinder fineness
levers are on top of each other.
Fit the lid (b) of the coffee powder shaft by
inserting it into the holder and turning it
into position.
9
To Next Page
Loading...
