Milk system cleaning program
Switch off the coffee machine with the
ON/OFF button. After dispensing a milk-
based coffee, the coffee machine performs a
rinsing cycle and then prompts you to clean
the milk system.
If the coffee machine automatically switches
itself off after dispensing a milk-based
coffee, you are prompted to clean the milk
system after 5 minutes.
If the milk system cleaning is not performed,
the coffee machine will prompt you again
the next time it is switched on. You can only
dispense coffee again when cleaning has
been performed.
The following symbols appear on the display:
Fill a container with 250m1 of warm water
and half a capful of Sunbeam liquid
descaler. Alternatively, dissolve 1 teaspoon
of bi-carbonate soda into 250mL of warm
water.
Insert the milk tube into the container.
Note: The slanted end of the tube must reach
the bottom of the container.
Press the s button to run the cleaning
program for the milk system.
The solution is fed out of the container via
the milk tube and drained into the drip tray.
The following appears on the display:
The cleaning process is completed
automatically.
The following appears on the display:
After completion, empty the container and
fill it again with 250m1 of warm water.
Insert the milk tube into the container.
Note: The slanted end of the tube must reach
the bottom of the container.
Press the ()button to continue with the
cleaning program.
The water is fed out of the container via the
milk tube and drained into the drip tray. The
following appears on the display:
4 4
The cleaning process is completed
automatically. It will then performs a rinsing
cycle.
The coffee machine subsequently prompts
you to empty the waste container. The
following appears on the display:
Empty the waste container after every use to
prevent mould from building up.
The coffee machine automatically switches
itself off after 60 seconds.
35
To Next Page
Loading...
