Remove the brewing unit by gripping the
front from underneath and pulling it out
towards yourself. Use your other hand to
stop it from falling out. See Figure 28.
Turn the brewing unit round. The brewing
unit is open and the ejector folded down.
The two stainless steel screens are now
freely accessible.
If the brewing unit is closed, you can loosen
it on the back with the help of the tool
function on the measuring spoon. Push the
toothed opening on the measuring spoon onto
the pin and loosen it by turning completely at
least 3 times.
Clean the brewing unit under hot running
water. In particular, the stainless steel
screens must be rinsed out well to remove
any coffee residue Use the cleaning brush
attached to the back of the measuring
spoon. See Figure 29.
Dry the brewing unit.
Replace the brewing unit by turning it into
the right position (the outlet tube facing
downwards and to the front), insert the
brewing unit into the guide grooves and
push it completely into the coffee machine.
See Figure 31.
Push the waste container into the coffee
machine and close the door.
Note: You can only switch on the coffee
machine when the brewing unit is fitted
and the door with coffee dispensing unit is
closed. After switching on, the brewing unit
is adjusted and the normal heating process
starts. During preparation of the first coffee
after cleaning, an increased amount of water
will run into the waste container.
To Next Page
Loading...
