Preparing coffee continued
Milk-based coffee
The milk system must be connected in order
to dispense milk-based coffees. Refer to page
10, Connecting the milk system.
When the espresso machine is turned on you
can select latte at one touch.
Always use milk from the refrigerator
(5-8 °C) as it produces the best frothing
result for milk-based coffees.
Note: Soy and rice milk do not produce as
good frothing results as regular milk.
Select the "milk-base coffee" function by
pressing the (B) button go.
The following appears on the display:
e
e
1E1 'It .5-
Select the desired milk-based coffee by
pressing the (C) button.
The following selections are possible:
Grande Latte
Caffe Latte
1.6 Cappuccino
approx.
270mL
approx.
180mL
approx.
200mL
Place one or two cups under the coffee
dispensing spout.
When preparing Latte Grande, push the
drip tray and the cup grate into the coffee
machine completely and place two glasses
onto the rest for tall glasses.
18
The coffee machine has default factory
settings. If you wish to change these settings,
refer to the instructions on page 22, Settings
for milk-based coffee.
The settings for milk-based coffee (coffee-
milk proportion, coffee filling quantity and
froth quantity) remain stored even when the
coffee machine is switched off.
In order to reduce heat loss and splashing,
adjust the dispensing spout height to suit
your cup/glass size by moving it up or
down. See Figure 13.
Note: If the height adjuster is difficult to
move, clean it. Proceed as described on page
31 Cleaning the height adjustor.
Select the desired ground coffee quantity
by pressing the (A) button. The following
selections are possible:
0
0 0 0 0 eitt.
0 0 0 0
0 0
elt, eg,
only "extra "light" "normal" "strong" "extra
milk" light" strong"
If you select the coffee ground quantity "0",
you can prepare hot milk.
The last-selected ground coffee quantity
remains set for each drink.
The set ground coffee quantity remains
stored even when the coffee machine is
switched off.
To Next Page
Loading...
