SunFounder picar-x
calibrate them in this step.
But if you think the assembly is perfect and no calibration is needed, you can also skip this step.
5.2 Calibrate the Car
After you connect the PiCar-X, there will be a calibration step. This is because of possible deviations in the installation
process or limitations of the servos themselves, making some servo angles slightly tilted, so you can calibrate them in
this step.
But if you think the assembly is perfect and no calibration is needed, you can also skip this step.
Note: If you want to recalibrate the robot during use, please follow the steps below.
1. You can open the product detail page by clicking the connect icon in the upper left corner.
2. Click the Settings button.
86 Chapter 5. Play with Ezblock
To Next Page
Loading...
