Sungrow Logger 3000 - Initial Parameter Setting

28
If the parameter set exceeds the allowable range, there will be a
note in red after the set value. During Query, if the set value exceeds
the allowable range or the device does not support such query, there
will also be a note in red after the set value.
8.7.3 Initial Parameter Setting
The string inverter can connect to the grid after setting the initial parameter
when it is installed for the first time. After connecting the SolarInfo Logger and
the inverter by RS485 cable, you can set the inverter initial parameters remotely
in batch by “Monitoring” – “Init-param. setting”.
Steps: select country – select grid type – initial settings – restart the device.