Sungrow Logger 3000 User Manual

37
After the add, delete, and modify operations, click the “ ” button to
save the present operation and the settings will be valid.
To change the device model, please conduct the delete operation first
and then click the “Save” button to make sure the delete operation is
effective.
Click “Add Device” to add the changed device info and click the “Save”
button to make sure the configuration is valid.
Example: to change the SG50KTL into SG40KTL and keep the address,
communication port and other info unchanged, proceed as follows:
Delete the SG50KTL and click the “Save” button.
Add the SG40KTL and click the “Save” button.
The SG50KTL device is changed to SG40KTL.
8.9 Settings
The settings module is to set the corresponding parameter of the Logger3000,
including: time settings, serial port settings, network settings, about, restart,
Modbus service settings, IEC104 service settings, and Cloud service settings.
8.9.1 Time Settings
Time settings is to set the system time of the Logger3000.
The Logger3000 can also set the time zone by selecting the local time zone
through the drop-down list.
Select “Settings” – “Time settings” to enter the system time setting interface.

Sungrow Logger 3000 Specifications

General

Brand	Sungrow
Model	Logger 3000
Category	Data Loggers
Language	English