38
Set the system time through the following ways.
1. Click “Sync. PC time to Logger3000” button to synchronize the time of the
PC and the Logger3000.
2. Input the “Date” and “Time” and click Save to set the time of the
Logger3000 manually.
8.9.2 Serial Port Settings
Serial port settings is to set the serial port of the Logger3000. Including com
port, function, baud rate, check bit, data bit and stop bit.
Select “Settings” – “Serial port settings” to enter the serial port setting interface.
If there is device connected to the serial port of the Logger3000, set the
function of this port to “Collection”. The settings of the Baud rate, check bit,
data bit and stop bit are the same with that of the devices connected to
To Next Page
Loading...
