(4) Pulley Location (Encoder) Test Function
1. After selection test mode, make”t-04”to be displayed.
Set the mode by pressing half-stitch key.
2. Turning by hands as shown in the figure, encoder angle
is displayed on the indication device.
3. End test by pressing half-stitch key.
(5) Synchro Test Function
1. After selection test mode, make”t-05”to be displayed.
Set the mode by pressing half-stitch key.
2. Turning by hands as shown in the figure, number of
pulley rotation is displayed on the indication device.
3. End test by pressing half-stitch key.
(6) Pedal Input Test Function
1. After selection test mode, make”t-06”to be displayed.
Set the mode by pressing half-stitch key.
2. Starting pedaling forward as shown in the figure, width
indication lamp turns off and stepping, base line
indication lamp turns off. And stepping backward the
pedal, indication lamp of start condense turns off.
3. End test by pressing half-stitch key.
(7) Aux out Test Function
1. After selection test mode, make”t-07”to be displayed.
Set the mode by pressing half-stitch key.
2. Pressing straight-line pattern key, all the 8 auxiliary output (J11 on digital board) turn on and pressing straight-line pattern
key again, all turn off.
3. End test by pressing half-stitch key.
<Note>
If value does not change, encoder system including connector
is in trouble.
<Note>
If value does no change despite turning more than 1
circulation, synchro system including connector is in
trouble
Encoder angle
pulley rotary number
Pedal start
Pedaling
Speed is displayed on
the indication device
Pedal thread
trimming
35
To Next Page
Loading...
