SunStar SPS/E-1306 Series - Default Chapter; Table of Contents

4
Contents
1. MACHINE TYPE AND SPECIFICATIONS
............................................................
6
1.1) Machine type
..........................................................................................................
6
1.2) Specifications of the machine
..............................................................................
7
2. SAFETY RULES
.........................................................................................................
8
2.1) Safety Stickers
.......................................................................................................
8
2.2) Machine Delivery
...................................................................................................
9
2.3) Machine Installation
............................................................................................
10
2.4) Machine Operation
..............................................................................................
10
2.5) Repair and Maintenance
....................................................................................
11
2.6) Devices for Safety
...............................................................................................
11
2.7) Location of Safety Labels
...................................................................................
12
2.8) Type of Safety Labels
.........................................................................................
12
3. ASSEMBLY
................................................................................................................
13
3.1) Name of Machine Parts
.....................................................................................
13
4. MACHINE INSTALLATION
....................................................................................
14
4.1) Installation Environment
.....................................................................................
14
4.2) Electricity Environment
.......................................................................................
14
4.3) Table Installation
.................................................................................................
14
4.4) Machine Installation
............................................................................................
15
4.5) Accessory Installation
.........................................................................................
17
5. PREPARATIONS BEFORE OPERATING THE MACHINE
............................
19
5.1) How to Supply Oil
................................................................................................
19
5.2) needle
..................................................................................................................
20
5.3) Thread
..................................................................................................................
21
6. HOW TO REPAIR THE MACHINE
.......................................................................
25
6.1) Adjusting the Height of the Needle Bar
...........................................................
25
6.2) Adjusting the Needle and the Shuttle
...............................................................
25
6.3) Adjustment of Lower Shaft Gear and Oscillating Shaft
..................................
26
6.4) Adjustment of Shuttle Upside Spring Position
.................................................
26
6.5) Adjusting the Height of the Feed Plate
.............................................................
27
6.6) Adjusting the Presser Foot Devices
..................................................................
27
6.7) Adjusting the Parts for the Presser Plate
.........................................................
29
6.8) Adjusting the Parts for Thread Release
...........................................................
29
6.9) Adjusting Parts for the Wiper
.............................................................................
31
6.10) Adjusting the X-Y Parts
....................................................................................
32
6.11) How to Set the Original Point of X-Y
...............................................................
33
6.12) Adjusting the Trimming Parts
...........................................................................
34