High Voltage Series | Installer Manual6
Compliance with the specications in this manual is also part of proper use.
The use of the High Voltage Series Battery system is prohibited in the following circumstances:
Mobile use on land or in the air (use on water only with the manufacturer's consent and with the manu-
facturer's written consent).
Used in medical devices.
Used as a UPS system.
The quality certicate can be downloaded from www.sunsynk.com.
Quality Certicate
All work shall comply with local applicable regulations and standards.
The installation of High Voltage Series Battery can only be completed by electricians with the following quali-
cations:
Trained in dealing with hazards and risks associated with the installation and operation of electrical
equipment, systems, and batteries.
Trained on installation and debugging of electrical equipment.
Understanding and complying with the technical connection conditions, standards, guidelines, regula-
tions, and laws applicable.
Knowledge of handling lithium-ion batteries (transportation, storage, disposal, hazard source).
Understanding and complying with this document and other applicable documents.
Installation video of High Voltage Series Battery can be found at www.sunsynk.com or contact us via
email: support@sunsynk.com
Requirements for Installation Personnel
To avoid property damage and personal injury, the following rules shall be followed when working on the
hazardous live parts of the battery energy storage system:
It is available for use.
Ensure that it will not restart.
Make sure there is no voltage.
Grounding protection and short circuit protection
Cover or shield adjacent live parts.
SAFETY
Safety Rules
Part damage or short circuit may cause electric shock and death. A short circuit can be caused by connecting
battery terminals, resulting in current ow. This type of short circuit shall be avoided under any circumstanc-
es. For this reason, follow these instructions:
Use insulated tools and gloves.
Do not put any tools or metal parts on the battery module or high-voltage control box.
When operating the battery, be sure to remove watches, rings, and other metal objects.
Do not install or operate this system in explosive or high-humidity areas.
When working on the energy storage system, rst turn o the charging controller, then the battery, and
ensure that they are not turned on again.
Safety Information
To Next Page
Loading...
Need help?
General