Duress Alarm
Press [ User Code with Last Digit + 1 ] + [ 0 ]
☼ The Line, Batt, Mains and Armed lights will blink once.
☼ The Armed light will turn off.
☼ The Line light turns on to indicate system dialler performing CMS reporting.
Remark:
Duress code = Last digit of User code increase by 1
Eg1. User code = 1234
Duress code = 1235
So to perform duress: [ 1235 ] + [ 0 ]
Eg2. User code = 9999
Duress code = 9990
So to perform duress: [ 9990 ] + [ 0 ]
Information
● Duress code is used to Disarm the system and transmit an emergency signal to your Central
Monitoring Station discreetly to indicate there is a duress situation. This is important if you are
being forced to Disarm your system against your will.
● Duress alarm can also be activated during Disarm state.
● Any User code used to activate Duress alarm will be reported to CMS if enabled.
● A previously armed system would not Disarm if an illegal Duress code is entered. You may have
up to 20 tries of continual key entry of the correct 4-digit Duress code before the keypad goes into
a lock-out period of 10 seconds.
L8_UM1016-v1.0
To Next Page
Loading...